Abstract
Ferroelectricity can be induced in fluorite-structured oxides such as HfO₂ and ZrO₂, a feature of increasing interest in both academia and industry. Initially, most research focused on solid solution films, but recently, it has been suggested that nanolaminates with independent HfO₂ and ZrO₂ layers may show electrical and physical properties..... More

Abstract
In this study we developed a novel (TRIP+TWIP) high entropy alloy (HEA) with high specific strength and large ductility. First, by controlling the atomic constitution of the 3d transition metals (Cr, Mn, Fe, Co, and Ni), we designed a light-weight TRIP-assisted dual-phase HEA with a non-equiatomic composition of Cr₂₂Mn₆Fe₄₀Co₂₆Ni₆, which..... More

Abstract
Al 7075 alloy was manufactured using the twin-roll strip casting (TRC) process, and the mechanical and wear properties of the fabricated TRC process were investigated. To compare the properties of the alloy manufactured by TRC, another Al 7075 alloy was fabricated by conventional direct chill (DC) casting as a comparative..... More

Abstract
Nanopatterning methods for pattern formation of high-resolution nanostructures are essential for the fabrication of various electronic devices, including wearable displays, high-performance semiconductor devices, and smart biosensor systems. Among advanced nanopatterning methods, nanotransfer printing (nTP) has attracted considerable attention due to its process simplicity, low cost, and great pattern resolution. However,..... More

Abstract
The dissimilar welding of titanium and copper by fusion welding is very difficult because the melting points of the materials are very highly different and strong brittle intermetallic compounds (IMCs) can be easily produced in welded zone and heat-affected zone, etc. Friction stir welding was employed as a type of..... More

Abstract
This study evaluated the effect of preheating on early stage melting behavior of a Al-Si coated hot stamped boron steel bolt during projection welding. A large amount of heat was generated in the early stage of projection welding. Because of the large heat generation, a rapid collapse of the projection..... More

Abstract
In this study, half-Heusler (HH) thermoelectric materials Nb_0.8Hf_0.2FeSb_0.98Sn_0.02 (p-type) and Hf_0.25Zr_0.25Ti_0.5NiSn_0.98Sb_0.02 (n-type) were synthesized using induction melting and spark plasma sintering. For alloying, a conventional induction melting technique was employed rather than arc melting, for mass production compatibility, and the thermoelectric properties of the materials were analyzed. The maximum dimensionless..... More

Abstract
Supercapacitor electrode slurry is prepared for mass production by mixing activated carbon powder, conductive agent, and binder, which is then deposited on a substrate using the doctor-blade method. Polyvinylidene fluoride (PVDF) and 1-methyl-2-pyrrolidone (NMP) are used as binder and solvent, respectively, to form the electrode slurry on a metal substrate...... More

Abstract
Radiation causes damage to the human body, the environment, and electronic equipment. Shielding against neutron and gamma rays is particularly difficult because of their strong ability to penetrate materials. Conventional gamma ray shields are typically made of materials containing Pb. However, they pose problems in that Pb is a heavy..... More