Abstract
The primary boundary of the CANDU reactor consists of Zr-2.5%Nb alloy pressure tubes and SA106 alloy feeder pipes. The pressure tubes are exposed to fast neutron (E>1Mev) irradiation during reactor operation, and experience dimensional changes. The actual dimensional change in the pressure tube during in-service operation is greater than the..... More

Abstract
Recently, lightweight vehicle bodies are in increasing demand to satisfy exhaust gas and environmental regulations around the world. In particular, aluminum alloys are widely used to manufacture lightweight parts, because of their excellent properties including corrosion resistance and mechanical properties. After the forming process, the welding process is important for..... More

Abstract
This study investigated the effect of the electromagnetic stirring (EMS) process on the microstructure and mechanical properties of hyper-eutectic Al-15 wt.%Si alloy. The tensile and high-cycle fatigue properties of the EMS Al-15wt.%Si alloy were examined and compared with conventional direct chill (DC) cast alloy. The initial microstructure of the as-cast..... More

Abstract
Kerfless wafering is a beneficial technique that enhances the cost effectiveness of crystalline silicon (c-Si) solar cells, preventing silicon (Si) waste during diamond sawing. This study compared the advantages of three stress layers for kerfless wafering: aluminum (Al) paste, epoxy-, and electroplated nickel (Ni). These materials demonstrated the ability to..... More

Abstract
Ge-doped tetrahedrites Cu₁₂Sb_4-yGe_yS₁₃ (y = 0.1–0.4) were prepared using mechanical alloying and hot pressing. An X-ray diffraction analysis after mechanical alloying showed a single tetrahedrite phase without secondary phases. The tetrahedrite phase was stable after hot pressing at 723 K under 70 MPa. As the Ge content increased, the lattice..... More

Abstract
Cu-based ternary chalcogenides composed of earth-abundant and nontoxic elements are considered promising thermoelectric materials, although there are few reports on them. In our previous studies, optimal mechanical alloying (MA) and hot pressing (HP) were used to synthesize Cu₃SbS₄ (famatinite) and Cu₃SbSe₄ (permingeatite). In this study, solid solutions of Cu₃SbS_4-ySe_y (y..... More

Abstract
Superplastic forming (SPF) is a promising approach used for manufacturing parts with complex geometries, especially in the automotive, aerospace, and marine industries. However, the wider use of this method is limited by issues of low forming rate, high-temperature requirement, non-uniform thickness distribution, and expensive base materials. The two-stage hybrid forming..... More

Abstract
A comprehensive analysis of the corrosion characteristics of excavated bronze artifacts was conducted according to their alloy ratio and microstructure. Corroded by various factors, which resulted in different corrosion characteristics. Among these, corrosion may occur in the excavated bronze due to the difference in the alloy ratio, which is an..... More