Abstract
This study was performed to compare the resistance spot weldability of Al 5052-H32 alloy and Al 6014-T4 alloy, and the cause of the differences in the weldability was investigated. In general, the surface of the aluminum alloy has an oxide film several nm thick, and local heat input is generated..... More

Abstract
Recently, lightweight vehicle bodies are in increasing demand to satisfy exhaust gas and environmental regulations around the world. In particular, aluminum alloys are widely used to manufacture lightweight parts, because of their excellent properties including corrosion resistance and mechanical properties. After the forming process, the welding process is important for..... More

Abstract
This study evaluated the effect of preheating on early stage melting behavior of a Al-Si coated hot stamped boron steel bolt during projection welding. A large amount of heat was generated in the early stage of projection welding. Because of the large heat generation, a rapid collapse of the projection..... More

Abstract
Generally, molds are fabricated by the machining of massive billets of tool steels, such as AISI4140 or H13, but it has drawbacks, such as a large material loss and long-delivery time. The Wire-Arc Additive Manufacturing (WAAM) process could be an alternative fabrication method. It has the advantages of less material..... More

Abstract
In this study, the effects of electrode surface design on the resistance spot weldability and degradation of the electrode following resistance spot welding (RSW) of aluminum 6014-T4 alloy were investigated. A new patterning method that can be produced through repetitive pressurization was applied to the electrode, producing a lattice-like pattern..... More